Return to previous page

Test bench valves

SITEC Test bench valves with pneumatic actuator for gases, air, mineral oils, brake fluids, etc

Specifications Catalogue page: 710.10 Catalogue page: 710.11 Catalogue page: 710.12
Pressure -0.8 - +40 bar max 500 bar max 300 bar
Temperature 90 °C -40 - 120 °C -40 - 120 °C

Features and advantages

  • Maximum reliability and safety at high pressures.
  • Gas-tight tested, over 1 million cycles. 100% bubble test.
  • Short opening/closing cycles: approx. 50 ms.
  • Long service life assured by fine ground stem with ceramic sealing tip and lip seal ring.
  • Fluids: Water, mineral oils and brake fluids.
  • Provision for direct mounting 3/2-way solenoid valve.
  • Replaceable seat – Easily exchanged. 
  • Simple assembly – Lens ring flange connection (model A), with tubing nipples (model B) or with O-ring seals (model C).
  • Concentric control air connection in air drive.
  • NO: normally open, air to close.
  • NC: normally closed, air to open.
  • Valve body in stainless steel AISI 316Ti.
  • All valves are available short-dated.
  • Professional sales and service back-up.

Options

  • Test bench valves for high and low temperatures.
  • Direct mounting 3/2-way solenoid valve.
  • Material and test certificates.
  • Double drive piston for 3 bar control air.
  • Provision for a “Reed”-contact for the remote recording of the valve position. Magnet included.
  • Blank flanges.
  • Connecting flanges.
  • Customized models available on request.