Return to previous page
Test bench valves
SITEC Test bench valves with pneumatic actuator for gases, air, mineral oils, brake fluids, etc
| Specifications | Catalogue page: 710.10 | Catalogue page: 710.11 | Catalogue page: 710.12 |
| Pressure | -0.8 - +40 bar | max 500 bar | max 300 bar |
| Temperature | 90 °C | -40 - 120 °C | -40 - 120 °C |
Features and advantages
- Maximum reliability and safety at high pressures.
- Gas-tight tested, over 1 million cycles. 100% bubble test.
- Short opening/closing cycles: approx. 50 ms.
- Long service life assured by fine ground stem with ceramic sealing tip and lip seal ring.
- Fluids: Water, mineral oils and brake fluids.
- Provision for direct mounting 3/2-way solenoid valve.
- Replaceable seat – Easily exchanged.
- Simple assembly – Lens ring flange connection (model A), with tubing nipples (model B) or with O-ring seals (model C).
- Concentric control air connection in air drive.
- NO: normally open, air to close.
- NC: normally closed, air to open.
- Valve body in stainless steel AISI 316Ti.
- All valves are available short-dated.
- Professional sales and service back-up.
Options
- Test bench valves for high and low temperatures.
- Direct mounting 3/2-way solenoid valve.
- Material and test certificates.
- Double drive piston for 3 bar control air.
- Provision for a “Reed”-contact for the remote recording of the valve position. Magnet included.
- Blank flanges.
- Connecting flanges.
- Customized models available on request.